Entegra PFD Series. The Avidyne Entegra EXP brings the advantages of integrated flight deck technology to the retrofit market for business and general. The Avidyne Entegra EXP brings the advantages of integrated flight deck technology to the retrofit market for business and general. Entegra EXP PFD. Document Revision History. This document is applicable to Software Part Number All materials.
|Published (Last):||7 May 2010|
|PDF File Size:||4.94 Mb|
|ePub File Size:||20.82 Mb|
|Price:||Free* [*Free Regsitration Required]|
Invalid Sensors and Error Conditions 5. If more than one radar indicator is installed in the system, all but one indicator must be in the OFF or STBY position in order for the system to enter the calibration mode. The article may be installed only if the installation is performed in accordance with Part 43 or the applicable airworthiness entfgra.
The Entegra EXP PFD may be coupled with the autopilot for altitude preselect, vertical speed select and heading select modes without the need for external controllers. The arrow indicates the direction of the wind relative to the current aircraft heading.
Avidyne Issues Service Alert For Entegra PFDs | Aero-News Network
entevra In aircraft with a volt system, the MFD is usually connected to a non-essential avionics bus. If warranty protection is applicable to the Product, Avidyne will use reasonable efforts to repair or replace Product within ten 10 business days of its receipt of the Product. The antenna may not be properly connected to the ground plane.
Specifications Avidyne leads the industry in datalink-capable multifunction displays and the EX and EX MFDs provide the most advanced, and easiest-to-use datalink systems you can get. You may not copy the Software for any purpose. This document is applicable to Software Part Numbers: Make sure that the structural aspects of the installation are performed in accordance with AC Ensure that the Dataloader is supported and not dangling by the cable.
Set the tilt table for 10o roll right.
Evaluate here, the installation for hazards contributed by FIS-B equipment malfunction that may cause loss or malfunction of other aircraft applications. Top Videos Airborne Table of Contents Add to my manuals Add. The versatile EX or EX MFD shows navigation data, broadcast datalink weather, lightning, traffic, obstacles, and terrain with an intuitive user interface.
The Map page opens and displays a single strike on the 15 mile range and 45 degrees relative bearing. If the value is out of range, repeat step L. If the strike does not appear in that position, there may be a heading source, wiring, or MFD setup problem.
Simultaneously press and hold buttons L1 top left and L3 3rd down on the left see Figure 7 for at least 5 seconds. Excessive noise can produce erroneous lightning strike indications.
Sample Traffic Setup Pages If you do not use it, no connection is required. The GAMA Graphics input can contain heading data, necessary for overlay capabilities as well as approach procedures and the display of curved segments.
Avidyne – EXP5000
Other brands or products are the trademarks or registered trademarks of their respective holders and should be treated as such. The available options are dependent on the aircraft model and additional purchased features. Datalink Avidyne leads the industry in datalink-capable multifunction displays and the EX and EX MFDs provide the most advanced, and easiest-to-use datalink systems you can get.
Other products in the Avidyne category. Avidyne recommends that you set the inbound course using the EXP Course Set knob to serve as reference during the localizer intercept and tracking.
Please provide us with all the entegea information and we’ll get back to you with specific product information! If the save procedure is successful, the GYRO fault will disappear and the azimuth count will cycle through its entire number range. This manual has been provided pursuant to an agreement containing restrictions on its use.
For more information about loading data for Release 3 and later, see the Avidyne Data Update Guide Document number Press Cancel to exit without saving changes. Heading Configuration with StormScope The System Entegr page opens: Select one of the following RS formats: The final list of affected PFDs may differ based on the results of Avidyne’s investigation.
Set the tilt table for 0o pitch and roll. When removing the rubber cap from the data port, pull the cap gently from the right EX or from the top EX until it pops out. Confirm that the chart is available. Introduction Notes and warnings provide guidance for the exp5000 of the EXP There is a local source of electromagnetic interference.
Configure the interface as follows: To clear the error, turn off power to the Lightning sensor and turn it on again. All materials copyrighted including images that represent this software. Using Trend Indicators 3 Rate of Turn Indicator—The tip of the blue rate of turn indicator displays the current rate of turn.
Contact Avidyne for more details. entegrx